Grundfos AMG Serie Instrucciones De Instalación Y Funcionamiento página 13

5.3.3 Installing a mixer
Mixers can be mounted in different ways, depending
on the accessories.
Motor bracket for mounting on column profile. See
fig.Installation of an AMG mixer.
15
17
1
Installation of an AMG mixer
Position numbers in figures Installation of an AMG
mixer and Installing a mixer
Pos. Description
1 Bottom fixation bracket
2 Column profile
3 Depth blocker
4 Motor bracket
5 Top fixation bracket including safety wire
12 Crane foot
13 Crane with winch
Lifting wire including shackle and wire
15
clamp
Pos. Description
17 Cable clamp
18 Cable sock including shackle
19 Intermediate fixation bracket
20 Wire clamp
31 Hole for fastening of safety wire
Procedure
See from fig. Installation of an AMG mixer to
a mixer for the referenced positions.
Make sure that the mixer cannot be turned
so much that the propeller touches the
tank wall.
Drill the holes for the anchor bolts for the top fixation
13
bracket in the concrete.
1. Mount the anchor bolts, and fit the top fixation
bracket.
2. Place the bottom fixation bracket in the right
12
position (vertically below the top fixation). The
5
bottom fixation bracket can be mounted in any
20
angle from vertical to horizontal position.
18
3. Drill the holes for the mounting anchor bolts for
2
the bottom fixation bracket.
19
4. Mount the anchor bolts, and fit the bottom fixation
4
bracket.
3
5. Depending on the length of the column profile,
weld the turnable part of an intermediate fixation
bracket to the column profile (pos. 19 in fig.
Installation of an AMG mixer).
6. Position and align the column profile in the bottom
fixation bracket. Shorten the column profile (pos. 2
in fig. Installing a
match the insulator (pos. C in fig.
mixer) at the top fixation bracket. A gap of 5 to 10
mm between collar of insulator and column profile
is optimal.
Installing
mixer) to the correct length to
Installing a
13