Grundfos AMG Serie Instrucciones De Instalación Y Funcionamiento página 22

18. Fix the power supply cable to the lifting wire by a
cable clamp approximately 0.8 m above the
flowmaker. This prevents the cable from falling
down and becoming entangled in the propeller
during operation. Connect the cable clamp to the
lifting wire above the wire clamp by a snap hook.
See fig. Attaching the cable to the wire. Attach the
power supply cable to the lifting wire by cable
clamps placed at 1 m intervals.
15
D
E
F
17
Attaching the cable to the wire
Pos. Description
D Power supply cable
E Snap hook
F Wire clamp
15 Lifting wire
17 Cable clamp
19. Position the crane in the foot, and mount the lifting
wire in the drum of the winch. See fig. Mounting
the lifting wire in the drum.
22
Mounting the lifting wire in the drum
At least three turns of wire must always
remain on the drum. Otherwise the
wire may break loose from the drum
fixation.
Follow the separate installation and op-
erating instructions for cranes.
20. Lift the flowmaker (motor bracket with motor)
using the crane and slide it over the column
profile.
21. Slowly lower the flowmaker into the tank and
down to position on the depth blocker.