Lutron STCL-153M Guía De Instalación Rápida

Quick Install Guide
How-to videos
lutron.com/SunnataWiring
STCL-153M
150 W 600 W *
Incand. / Halogen
LED / CFL
Please read before installing
FCC Supplier Declaration of Conformity / IC:
This device complies with part 15 of the FCC Rules and
Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation. Modifications
not expressly approved by Lutron Electronics Co., Inc. could
void the user's authority to operate this equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV
technician for help
CAN ICES-5 (B)/NMB-5(B)
Included Parts
Dimmer Wire Nut
Yellow (x4)
Blue (x1)
Disconnect Power
WARNING: SHOCK HAZARD. May result
in serious injury or death. Turn off power at
circuit breaker or fuse before installing.
Option 2: 3-Way / 4-Way with Sunnata Accessory Switch(es)
For lights switched from two or more locations:
See Sunnata Accessory Switch Installation Guide (model ST-AS) for details.
For lights switched from two locations:
IMPORTANT: Before disconnecting the existing devices, tag the wire connected to the different colored screw (typically black,
but wire colors vary, and labeled COM). This is the Common wire.
QUESTIONS? See lutron.com/SunnataWiring
Location 1
Red
Non-black
Blue
Common
Black
(tagged)
Insert and
twist to
tighten
Green wire
Adjust Low-End Trim
Operation
IF LIGHTS ARE OFF, single tap top button for preset (default 100%).
Double tap for full brightness.
To change the preset, visit lutron.com/SunnataMyLevel.
IF LIGHTS ARE ON, single tap top button for full brightness.
Press and hold the bottom button (1 second) for a 30 second
delayed fade-to-off. Single tap bottom button for off.
On
Off
Limited Warranty:
lutron.com/TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf ©2019-2021 Lutron Electronics Co., Inc.
Lutron, LED+, and Sunnata are trademarks or registered trademarks of Lutron Electronics Co., Inc., in the U.S. and other countries.
The YouTube icon is a trademark of Google LLC.
Receive an Extended Warranty: lutron.com/SunnataSurvey
Support: 1.844.LUTRON1 (USA / Canada)
Sunnata LED + Dimmer
Use included diagrams
or visit our website for
step-by-step instructions.
Ganging and Derating
Derating is necessary if mounting two
or more devices side by side (see
chart for new wattage rating).
Note: Derating not necessary for LED /
CFL loads.
*Maximum Allowable Inc. / Hal. Wattage
Single
Gang
600 W
INSTALL WITH CONFIDENCE
VIDEO & STEP-BY-STEP INSTRUCTIONS VIDEO & STEP-BY-STEP INSTRUCTIONS
l u t ro n . c o m / S u n n a t a Wi r i n g
Screws (x2) Jumper Wire
(Only needed for
Option 3. Not
included with
STCL-153MRH.)
Option 3: 3-Way with an Existing Switch
wire
Ground wire
(bare or green)
1. Touch the middle of the light
bar until the light bar begins
to flash (~6 sec.).
2. Set lowest dimming
range where lights are on
and stable.
3. Tap the OFF button to save.
lutron.com/sunnatasupport
Install with
confidence
End of Gang Middle of Gang
500 W 400 W
For lights switched from one location:
NOTE: Red and black wires on dimmer are interchangeable.
Location 2
BEFORE
Non-black
Required
Common
for 3-way
(tagged)
Different
color screw
MyLevel Personalization (optional)
Visit lutron.com/SunnataMyLevel
• High-end dimming range
• Preset light level
• Light bar brightness
• Locator light / Light level indicator
Symptom
Light have poor dimming
performance
For more information, please visit
lutron.com/SunnataSupport
+1.888.235.2910 (Mexico)
120 V~ 60 Hz
Find the right LED
lutron.com/LEDfinder
Important Notes
1. CAUTION: Use only with permanently installed
fixtures with dimmable screw-in compact fluorescent,
dimmable screw-in LED, halogen, or incandescent
lamps. To avoid overheating and possible damage to
other equipment, do not use to control receptacles,
motor-driven appliances, or transformer-supplied
appliances.
2. Install in accordance with all national and local
electrical codes.
3. When no "grounding means" exists in wallbox, the
National Electrical Code (NEC
installed as a replacement when a plastic faceplate with
plastic fasteners is used, or the circuit is protected by a
ground fault circuit interrupter (GFCI). Lutron wallplates
meet this requirement. Cap or remove green wire before
screwing control into wallbox.
4. Protect the dimmer from dust and dirt when painting or
spackling the wall.
5. It is normal for the dimmer to feel warm to the touch
during operation.
6. Clean the dimmer with a soft damp cloth only. Do
not use any chemical cleaners. For more information,
please see lutron.com/cleaning
7. For indoor use only.
Option 1: Single Pole
Red
Use blue
connector
Blue
Black
Insert
and
twist to
tighten
Ground wire
Green wire
(bare or green)
wire
Ground wire
(bare or green)
to learn how to adjust:
Troubleshooting
Possible Cause
Adjust low-end trim
Find best performing bulbs
at lutron.com/LEDFinder
) allows a control to be
®
English
AFTER RE-WIRING
Non-black
wire
Common
(tagged)
Yellow
jumper Ground wire
wire (bare or green)