Publicidad
Idiomas disponibles
Idiomas disponibles
8.MAINTENANCE OF THE APPLIANCE
EN
To ensure that your coffee retains the highest possible quality, regular maintenance of your
machine is important.
For daily use in the home, it is advisable to service your machine every 1 to 3 months (or after
200 coffees).
To do this, lift the lid of the bean container (no. 1 in the general diagram). Then remove the
transparent cover of the maintenance product compartment (n°9 on the general diagram) and
insert a specific maintenance tablet (or gel) for automatic coffee machines.
Then start two consecutive cleaning cycles by pressing the
button.
DESCALING
Caution: before descaling, please place a container under the steam and coffee nozzles to collect
the dirty descaling water.
Automatic descaling:
After using 20 litres of water, the machine will automatically remind you that descaling is necessary,
all the setting icons (D) will be lit and the long espresso icon will
blink.
Please press the long espresso icon
, the machine will start and end the descaling process
automatically. However, if you wish, there is also a manual mode.
Manual descaling:
Depending on the quality of the water used, especially if the water hardness is high, manual
descaling may be necessary in addition to automatic descaling.
1.When the coffee machine is switched on, add the decalcifying liquid to the water tank, then press
the Espresso
and Long Espresso
for 5 seconds to start the descaling process.
2.The indicator lights (C) light up alternately and all the setting icons (D) light up. Every 3 minutes,
the machine pumps water from the coffee spout for 10 seconds and from the steam nozzle for 5
seconds. The machine makes 9 revolutions to remove the scale inside the machine.
3.After the above process, all function icons (B), indicator lights (C) and setting icons (D) will light
up, indicating that it is necessary to change the water in the tank.
4.After pouring fresh water into the tank, press the Long Espresso icon
, then the machine
will pump out 300 ml of clean water, in order to clean the internal descaling water, and will
automatically finish the descaling process.
SWITCHING OFF
Press the power icon
, the machine switches off and goes into standby mode after a self-
cleaning process.
RESET TO FACTORY SETTINGS
To return to the original temperature and coffee quantity settings, please follow the instructions below.
When the coffee machine is switched on, press the long espresso icon
and the cleaning icon
for 5 seconds, the indicator lights (C) will light up in turn. Wait until the indicator lights go out and
the first 4 function icons (B) light up. The factory reset is complete and the machine is ready for use.
12
Publicidad
