Publicidad
Idiomas disponibles
Idiomas disponibles
CARE, CLEANING AND STORAGE
Always switch off and unplug the heater before cleaning. Allow it to cool. Use only
a clean, dry or slightly moistened cloth to clean the external surfaces only.
1. Remove the two screws securing the top cover to the rear of the main unit.
2. Remove the guard grill.
3. The lattice grill retaining lugs should be bent upwards and the lattice grill can
then be removed.
4. The halogen elements can then be removed by holding them in the centre using
a cloth, sliding them slightly to one side before pulling them forward.
Avoid direct finger contact with the halogen element glass.
5. The reflector can then be cleaned using a cloth dampened with mild detergent.
Do not use solvents, chemicals or polish on the reflector.
6. The lattice mesh can be cleaned using a soft brush or vacuum cleaner.
7. Reversing the above steps should then assemble the heater.
Allow the heater to cool before storing. Packing the heater in its original carton
provides the best protection to store the unit in a cool and dry location.
WARNING: Fabric, clothing or other flammable materials may ignite if placed against
or in close proximity to the heater. No flammable materials should be placed within 1
metre of the front or sides or 0.5 metres of the rear of the heater.
The tip-over switch push rod must not be tampered with or jammed into position, as
this will disable the tip-over safety cut out operation.. The heater must be placed on a
firm even surface to ensure the correct operation of the tip-over switch. Locating the
heater on an uneven surface may result in the switch failing to operate making the
heater inoperable.
READ AND SAVE THESE INSTRUCTIONS
7
Publicidad
