Dimplex XLF60 Manual Del Propietário página 12

Fireplace Installation (continued)
120V Installation - Plug Kit
WARNING: This heater is
not intended for use with an
extension cord. Plug the cord
directly into an ap propriate
wall receptacle.
To install a plug kit:
1. Locate the rear cover plate
about 12 in. (30.5 cm) from the
left side at the bottom. Remove
the 3 screws that hold the plate
(Figure 8).
2. Feed wire from plug kit into
opening and attached using the
using the 3 screws.
Figure 8
12
All manuals and user guides at all-guides.com
3. Connect the L1 wire from the
4. Connect the N wire from the
5. Connect ground wire from the
6. Ensure that all wire connections
7. Continue to final installation.
unit to the black wire of the plug
kit.
fireplace to the white wire from
the plug kit.
fireplace to the green wire from
the plug kit.
are tight and that wires are
secured and do not protrude
past the flame panel, so as
not to be visible after final
installation.
www.dimplex.com