Dimplex XLF60 Manual Del Propietário página 7

Fireplace Installation
CAUTION: Ensure installation
does not allow fireplace to be
in direct contact with building
vapor barrier or insulation and
meets all local building code.
!
NOTE: A dedicated, properly
fused 15 Amp circuit is required,
rated for the appropriate voltage
(120V, 240V).
WARNING: Construction
and wiring must comply with
local building codes and other
applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
WARNING: To reduce the risk
of fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: To reduce the
risk of fire, do not store
or use gasoline or other
flammable vapors or liquids
in the vicinity of the heater.
1. Select a location that is
not susceptible to moisture
and is away from drapes,
furniture and high traffic.
2. Unpack the fireplace and
hardware from the box.
All manuals and user guides at all-guides.com
3. Store the fireplace in a safe, dry
Framing
This design of this unit allows
three options for installation:
partial recess, flush mounted or
sub-surface mounted.
Figure 2
2" x 6"
5 1/2" (14.0 cm)
2" x 4"
3 1/2" (9.0 cm)
!
NOTE: Leave the front glass
and partially reflective glass,
safely, in the box until the time
you are ready to install it.
and dust free location until you
are ready to install the fireplace.
CAUTION: Two people will be
required for various steps of this
procedure.
XLF60: 60 5/8" (154.0 cm)
16"
(40.6 cm)
7