Dimplex XLF60 Manual Del Propietário página 17

Operation
General Operation
WARNING: This electric
firebox must be properly
installed before it is used.
This firebox operates with
Comfort$aver technology,
TM
which automatically adjusts the
fan speed and heater wattage to
safely and precisely match the
requirements of the room based on
the thermostat setting. The heater
operates such that once the room
reaches the set point, the fan and
heater will continuously run at a low
level, to maintain the desired room
temperature. If the temperature in
the room rises significantly, (e.g.,
sun coming through a window or a
central furnace turns on) the heater
will turn off and periodically turn
back on to circulate the air around
the unit, until the room temperature
drops and requires the heater to be
constantly on again.
! NOTE: The unit is designed so
that the fan will run continuously
while the heater is on.
! NOTE: The unit retains heat
after shutdown. When the
heat is turned OFF, there is a
2-minute, built in cool down
period before the fan shuts off.
All manuals and user guides at all-guides.com
Remote Operation
The fireplace is supplied with an IR
multi-function remote control.
Controls
The unit can be controlled by
either the manual controls which
are located on the upper right of
the fireplace or the remote
(Figure 12 and 13).
A.
Turns the unit On and Off.
• The unit will turn On with the
! NOTE: To operate correctly, the
remote control must be pointed
towards the front of the unit.
Standby
Activated by pressing the
Standby button on the remote
or the unit.
same functions that it was set
to when it was turned Off and
the intake temperature will be
indicated on the Display.
! NOTE: When any button is
pressed on the unit the intake
temperature will be displayed on
the Display for 7 seconds.
17