Baumgartner MedRhein Pluslife POC-NAT Instrucciones Del Producto página 31

Chapter III Operation Introduction
1. Pre-amplification preparation
Connect the power supply, press the power button to start the device and enter
warm-up state. After about 2 mins, warm-up is completed and the device enters
standby state (Figure 1).
2. Start of amplification
Insert the reaction card into the device and close the top cover. Press the power
button to start amplification.
3. Amplification exception handling
When the power indicator flashes and the beeper sounds simultaneously, the
device is in exception state, press the button for 3 seconds to end the test.
4. End of amplification
After amplification, you can start the next test directly, or press the button for
3 seconds to turn off the device.
Figure 1
- 13 -