Preparing To Work - GGP ITALY BL 2.6 E Manual De Instrucciones

PREPARE THE MACHINE / PREPARING TO WORK
NOTE
the flat part of the blower chute is pointed towards
the ground.
• To remove the blower tube (5) press the tab (6)
on the bottom part.
2. TO USE AS A VACUUM COLLECTOR
(Fig. 2)
• Remove the intake grille (if previously applied).
Then:
– Align the compartment of the first vacuum tube
(1) with the protrusion (2) of the second tube
and push it to the end so that the two tubes are
firmly united.

5. PREPARING TO WORK

1. CHECKING THE MACHINE
WARNING!
not plugged into the mains socket.
Before starting work please:
– check that the mains frequency and voltage is
the same as the rating data on the "Identification
Plate" (see chap. 1 - 2.7).
– check that the switch lever moves freely with-
out being forced, and when released, it returns
automatically and quickly to the neutral position;
– check that the cooling air vents are not ob-
structed;
– check that the power cable and extension lead
are not damaged;
– check that handgrips and protection devices
are clean and dry, correctly mounted and well
fastened to the machine;
– check that the machine is not showing signs of
wear or damage due to knocks or other causes,
and carry out the necessary repairs.
– when used as a vacuum collector, make sure
the bag is integral, well-closed and that the zip-
per works correctly;
– prepare accessories according to the type of
work (as blower or vacuum collector) and make
sure they are correctly mounted;
Assembly is correct when
Make sure the machine is
– Apply the top part (with knob) of the first tube (1)
to the power unit (3), positioning it as indicated
and turning it 90° clockwise.
– Fasten the top of the first tube (1) to the power
unit (3) fastening it to the catch (4) with the spe-
cific lever (5).
– Align the bag fitting tube (6) to the opening of the
power unit and push it to the end until it firmly
locks into place.
– Fasten the clasp (7) of the bag to the specific
fitting (8) found on the second tube.
• To remove the bag, press the tab (9) on the
bottom part of the fitting tube and unfasten the
clasp (7).
2. ELECTRICAL CONNECTIONS
DANGER!
are not compatible.
– Always handle and connect electric cables
in dry conditions.
– Keep electric sockets or cables away from
wet and damp areas (e.g. puddles or wet
ground).
– Power the machine using a residual current
device (RCD Residual Current Device) with
max. 30 mA tripping current.
The quality of the extension leads must be no less
than H07RN-F or H07VV-F, with a minimum sec-
tion of 1.5 mm and a recommended maximum
length of 30 m.
To avoid overheating, do not keep the extension
lead rolled up during use.
DANGER!
tion of any electrical equipment to the mains
of a building must be installed by a qualified
electrician in conformity with the regulations
in force. Incorrect wiring can cause serious
injury and even death.
EN
Electricity and moisture
The permanent connec­
21