Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Display Settings - Sony CDX-V7800X Manual De Instrucciones

Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader.
You can store the bass and treble levels
independently for each source.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
Each time you press (SOUND), the item
changes as follows:
BAS (bass) t TRE (treble) t BAL (left-right)
t FAD (front-rear)
2
Adjust the selected item by pressing
either side of (SEEK/AMS).
When adjusting with the rotary
commander, press (SOUND) and rotate the
VOL control.
Note
Adjust within three seconds after selecting the
item.

Attenuating the sound

Press (ATT) on the rotary commander or
card remote commander.
"ATT-ON" lights up for a while.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes
in (Telephone ATT function).
22
Changing the sound and
display settings
The following items can be set:
SET (setting)
•CLOCK (page 9)
•BEEP — to turn the beeps on or off.
•RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select "NORM" to use the rotary
commander as the factory-set position.
— Select "REV" when you mount the rotary
commander on the right side of the
steering column.
•PAL/NTSC* — to change the TV colour
system to PAL or NTSC.
DIS (display)
•D.INFO (Dual Information) — to display the
clock and the play mode at the same time
(ON).
•M.DSPL (Motion Display) — to turn the
motion display on or off.
Note
If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be disabled.
1
Press (MENU).
2
Press either side of (PRST) repeatedly
until the desired item appears.
Each time you press the (–) side of
(PRST), the item changes as follows:
CLOCK t BEEP t RM t D.INFO t M.DSPL
t PAL/NTSC*
* This item can be selected when the unit is
turned off (clock indication).
Note
The displayed item will differ depending on
the source.
Tip
You can easily switch among categories ("SET",
"DIS", "EDT" (edit mode), and "P/M" (play
mode)) by pressing either side of (PRST) for
two seconds.