Adjusting The Sound Characteristics; Muting The Sound; Changing The Sound And Display Settings - Sony XR-C7200W Manual De Instrucciones

Press (SOUND) two seconds while
pushing the VOL control.
Tip
You can change the operative direction of controls with the
unit, refer to "Changing the sound and display settings".
Adjusting the sound
characteristics
You can adjust the bass, treble, balance and
fader.
Each source can store the bass and treble level
respectively.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n BAS (bass) n TRE (treble) n
BAL (left-right) n FAD (front-rear)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selection.
(After three seconds, the dial works as the
volume control dial.)

Muting the sound

The unit decreases the volume automatically
when a telephone call is received (Telephone-
mute function).
Changing the sound and
display settings
You can set:
• Clock (page 5)
• D. Info (Dual Information) to display the
clock and the play mode at the same time
(ON), or to display the information
alternately (OFF).
• Amber/Green to change the illumination
color to amber or green.
• Dimmer to change the brightness of the
display.
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
• Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
• Beep to turn on or off the beeps.
• RM (Rotary Commander) to change the
operative direction of the controls of the
rotary commander.
— Select "norm" to use the rotary
commander in the factory preset position.
— Select "rev" when you mount the rotary
commander on the side right of the
steering column.
• Loud (Loudness) to enjoy bass and treble
even at low volume. The bass and treble will
be reinforced.
• A. Scrl (Auto Scroll) (page 12)
Note
The displayed item will differ depending on the source.
1
Press (SHIFT), then press (2) (SET UP).
2
Press (2) (SET UP) repeatedly until the
desired setting mode appears.
Each time you press (2) (SET UP), the item
changes as follows:
Clock n D.Info n Amber/Green n Dimmer n
Contrast n Beep n RM n Loud n A.Scrl
3
Press (4) (n) to select the desired
setting (for example: "on" or "off").
For the "Contrast" setting, pressing (4)
(n) makes the contrast higher, and
pressing (1) (N) makes the contrast lower.
4
Press (SHIFT).
When the mode setting is complete, the
normal playback mode appears.
EN
11