Publicidad
C C a a r r a a c c t t e e r r í í s s t t i i c c a a s s
5 5
En este capítulo encontrará informaciones relativas a las
características técnicas y a las certificaciones de la impresora.
D D e e c c l l a a r r a a c c i i ó ó n n d d e e c c o o n n f f o o r r m m i i d d a a d d e e s s T T a a t t t t o o o o
Concerning Safety and Electromagnetic Compatibility
Manufacturer's Name:
Manufacturer's Address:
Material Designation:
Year of Manufacture:
I, the undersigned, Serge Olivier,
Declare that I have received the assumption of the above material(s), used and installed in accordance with the notice, with the essential requirements
of Directives 2006/95/EC and 2004/108/EC by the application of the following regulations:
EN 60950-1 of 2001
EN 55022 Class B of 1998: A1 (2000), A2 (2003)
EN 55024 of 1998: A1 (2001), A2 (2003)
EN 61000-3-2 of 2000
EN 61000-3-3 of 2000 +A1 of 2001
Full name: Serge Olivier
Title: Technical Manager
Date: September 2007
Signature:
E E U U R R O O P P E E - Norway Only: This product is designed for IT power system with phase-to-phase voltage 230V. Earth grounding is via the polarized, 3-wire power cord.
FI: "Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan" - SE: "Apparaten skall anslutas till jordat uttag" - NO: "Apparatet må tilkoples jordet stikkontakt"
FCC Statement (for U.S.A.)
Federal Communications Commission Radio Frequency Interferences Statement
Tattoo2 model conforms to the following specifications: FCC Part 15, Subpart A, Section 15.107(a) and Section 15.109(a) Class B digital device.
Supplemental information:
This equipment has been tested and finds to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference's by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not expressly approved by Evolis Card Printer may cause,
harmful interference and void the FCC authorization to operate this equipment.
VCCI (for Japan)
This is a Class B product
based on the standard of the
Voluntary Control Council for
Interference from Information
Technology Equipment (VCCI).
If this is used near a radio or television receiver
in a domestic environment, it may cause radio
interference. Install and use the equipment
according to the instruction manual.
End of life product disposal
This symbol indicates that Waste Electrical and Electronic Equipment (WEEE) must be disposed of separately from normal household
waste in order to promote reuse, recycling and other forms of recovery and to reduce the quantity of waste to be eliminated though
landfill. WEEE includes accessories such as remote control, batteries, AC adaptor, etc. When you dispose of such products, please
contact your distributor or Evolis at info@evolis.com
Evolis Card Printer
14, avenue de la Fontaine
Z.I. Angers Beaucouzé
49070 Beaucouzé - France
Tattoo2
2007
39
Publicidad
