Publicidad
Idiomas disponibles
Idiomas disponibles
9
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial solutions. For ease of adding other solutions remove
the reservoir (see "When Finished" section) and add from opening on reservoir. If you are adding additional water you may replace the
reservoir and fill reservoir fully with the fill door. After using any special solution, rinse unit to prevent clogging by partially filling reservoir
with warm water and running unit with tip pointed into sink until unit is empty.
Cleaning
Remove
Never immerse unit in water. Before cleaning, unplug from the electrical outlet. Clean the product when necessary by
using a soft cloth and mild nonabrasive cleanser to wipe exterior. The water reservoir is removable for easy cleaning. It is recommended
that the reservoir is removed and cleaned weekly.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of your water. If left unattended, it can hinder
performance. Cleaning internal parts: add 1 tablespoon of white vinegar to a full reservoir of warm water. Point the handle and tip into
sink. Turn unit ON and run until reservoir is empty. Rinse by repeating with a full reservoir of clean warm water. This process should be
done every 1 to 3 months to ensure optimal performance.
Publicidad
