Publicidad
Idiomas disponibles
Idiomas disponibles
6
GETTING STARTED
Reservoir is
empty and
collapsed
Charge
USB wall charger
is not standard
accessory
with this
appliance.
Fill
Insert
INSERT
Eject
EJECT
Charging Unit Prior to First Use
Charge unit for approximately 4 hours prior to first use. Plug the user supplied USB wall charger into a wall outlet and connect the USB
charging cable to the unit (see images). Refer to the IMPORTANT SAFEGUARDS section for required USB wall charger specifications.
Ensure contacts on BOTH the cord and the unit are clean and dry, and the reservoir is empty and collapsed. The LED light
will emit a slow glow on/off when unit is charging. Once the unit is fully charged and the charger is connected the LED will remain
on until the charger is disconnected. A full charge will last up to 4 weeks of typical use. When the batteries are in need of charging
(approximately 30% charge left) the charge indicator light emit a rapid triple blink during and after use to indicate that you should
recharge the unit.
A complete recharge will take 3-4 hours. If you use your Water Flosser once a day or less, it is recommended you charge every 3-4 weeks.
If you use it twice a day or more, charge more frequently.
Put the protective charging port cover back into place before use. The charging port cover should only be removed for charging.
Filling the Reservoir
Remove the charging cable from the unit and replace charging port cover prior to filling reservoir and product use. Pull down on reservoir
to open. Unit will "click" into place when fully extended. Lift flip top on reservoir and fill the reservoir with lukewarm water.
Collapse by pushing reservoir up. Reservoir will "click" into place when fully closed.
Inserting and Removing Tips
Insert tip at the top of the unit. Press firmly until the tip clicks into place. To remove the tip from the unit, press the tip eject button and
pull tip from the unit.
CAUTION: Do not press tip eject button while unit is running.
Publicidad
