Jole i-chapp Manual De Instrucciones página 6

Make the webbing and clip wind
round bar, then tension webbing.
7 8
!
Slide shoulder harness anchor
to adjust webbing length.
!
Through the shoulder belt into
the shoulder belt positioning
clip, Slide the shoulder belt
positioning clip to make sure
the clip is close to child's
shoulder, -1 buckle the
9
vehicle safety belt.
9
9
9
7
8
-3
1
2 3
4
!
To achieve the safest
installation, we suggest the
shoulder belt positioning clip
should be level with the
highest point of the child's
shoulder.
DO NOT position vehicle belt
over top of the armrests. It must
pass underneath the armrests.
-2
9
The booster can not be used if
the vehicle safety belt buckle
(female buckle end) is too long to
anchor the booster securely.
!
After your child is placed in
this booster, the safety belt
must be used correctly, and
ensure that any lap strap is
worn low down, so that the
pelvis is firmly engaged.
!
Place a booster firmly against
the back of a forward-facing
vehicle seat equipped with a
lap/shoulder belt.
!
Any straps holding the booster
to the vehicle should be tight ,
any straps restraining the child
should be adjusted to the
child's body, and the straps
should not be twisted.
-4
9
9
10