Publicidad
Idiomas disponibles
Idiomas disponibles
5. To set time and week
1) To set time
When the appliance is running, from home page press
hour start flash, press
Then press
Then press
2) To set week (only for M12 and M13 series)
When enter week page ， week start flashing, press
Then press
button to confirm and return to home page.
6. To start heat pump on boost cycle
From home page press
will heat at the same time.
Press
again to turn off boost cycle.
When boost cycle is turned on, the BOOST icon will light up, or else it will light off.
7. To turn on/off silent function
Press
button to turn on/off the silent operation.
When silent function is turned on, fan will run at low speed to reduce running noise.
When silent function is turned on, the silent icon will light up, or else the silent icon will light off.
When silent function is turned on, heat pump will run with silent mode during the scheduled
hours. There are two schedules available for silent operation.
Default from factory： schedule1 start time: oP:13, schedule1 stop time cL:14； Schedule2 start time:
oP: 22, schedule2 stop time cL: 06.
If need to change scheduled time, follow step below:
From home page, press
start flash, temperature area display 01, time area display "oP:XX",press
to set start time for schedule1.
Then press
start flash, temperature area display 01, time area display "cL:XX",press
to set stop time for schedule1.
Then press
Then press
or
button to adjust hour setting.
button, minutes start flash, press
button to confirm and switch to week page.
button for 3s to start boost cycle. The compressor and electric heater
button for 3s to enter silent scheduled time setting page.
button switch to stop timer for schedule1.
button switch to schedule2, following same steps above to set schedule2.
again to confirm and return to home page.
button to enter time setting page,
or
button to adjust minutes setting.
or
button to adjust week setting ，
19
or
button
or
button
Publicidad
