GreenWorks G24PS20 Manual Del Operario página 5

EN
1 DESCRIPTION
1.1 PURPOSE
This chainsaw is designed for cutting branches, trunks, logs
and beams of a diameter determined by the cutting length of
the guide bar. It is only designed to cut wood.
It is only to be used in an outdoor, domestic application by
adults.
Do not use the chainsaw for any purpose not listed above.
This chainsaw is not to be used for professional tree services.
It is not to be used by children or by persons not wearing
adequate personal protective equipment and clothing.
1.2 OVERVIEW
Figure 1-20
Trigger
1
Lock-out button
2
Pole
3
Shoulder strap
4
Collar
5
Extension pole
6
Guide bar cover
7
Oil tank cap
8
Chain
9
10 Bar
11 Scabbard
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
12 Pole saw head
13 Pole saw handle
14 Chain lubricant
15 Oil indicator
16 Battery
17 Chain cover lock
knob
18 Sprocket
19 Chain tension pin
hole
WARNING
WARNING
English
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt enters
in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for 15 - 40 minutes.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 10-14
1. Remove the battery pack from the machine.
2. Loose the chain cover by turning the chain cover knob
counterclockwise.
3. Remove the chain cover.
4. Put the chain drive links into the bar groove.
5. Put the chain cutters in the direction of the chain
operation.
4
WARNING
IMPORTANT
NOTE
IMPORTANT