LUND 68172 Manual De Instrucciones página 11

Warning! Do not uncover the lid when boiling water.
When using the kettle always close the lid, otherwise the automatic product switch will not be triggered. Do not open the lid of the
kettle immediately after water has been boiled. Condensed steam of high temperature may be accumulated under the lid. Contact
with steam can cause a burn.
Note! Place the lid in such a way that steam escapes away from the holder.
The product has been designed for home use and it is forbidden to use it in commercial applications, e.g. in catering facilities.
Unattended repair, disassembly or modifi cation of product is forbidden. All product repairs must be carried out by an authorised
repair point.
This product is not intended for use by children below 8 years of age and persons with reduced physical or mental capabilities
and person with no experience or knowledge of the equipment. Unless they are supervised or trained how to use the product in a
safe manner so that the risks involved are understood. Children should not play with the product. Unattended children should not
perform cleaning and maintenance of the equipment.
Do not use any corrosive substances, solvents, corrosive agents, alcohol, gasoline or abrasive agents for cleaning.
PRODUCT HANDLING
Product should be unpacked, completely removing all packaging components. Unwind the cord. Prepare the base as per instruc-
tions.
Before the fi rst use, the kettle should be cleaned as per instructions included in chapter on product maintenance.
Check if the kettle has the fi lter installed correctly.
Model 68172
Lift the lid by pressing the button.
Fill the kettle with water so that its level remains between the minimum and maximum level markers. Cover the lid of the kettle.
Connect the power cord to the mains socket.
Make sure that the switch remains in "OFF" position - O.
Place the kettle on the base so that the kettle adheres to the base with its entire perimeter.
Switch-on the kettle with the switch, turning it to the "on" position - I.
Kettle's light indicator will be visible throughout the entire cooking time.
After the water boils, the kettle will automatically switch off . The switch will automatically change the position to "off " - O and light
indicator will turn off .
Raise the kettle from the base by grasping the handle only.
It is not necessary to open the lid for pouring water.
Unplug the power cord from the mains socket.
After the use, leave the product to cool. down.
Note! Turning the switch manually to the "off " position - O, completes the process of heating water at any time.
Control panel (applies only to 68173 and 68174 models)
The kettle has been fi tted with a control panel that signifi cantly expands its functionality.
In case of 68173 model the control panel is located in the handle, and in case of 68174 model in the base of the product.
Handling of control panel is realised by means of buttons, reading us visible on the display.
Pushing the I/O switch allows switching in and off the kettle.
Buttons marked with "+" and "-" allow setting the temperature at which water heating is completed.
Button marked with a symbol of cap allows switching in water temperature sustaining function.
Model 68173
Lift and dismantle the lid.
Fill the kettle with water so that its level remains between the minimum and maximum level markers. Cover the lid of the kettle.
Connect the power cord to the mains socket.
Place the kettle on the base so that the kettle adheres to the base with its entire perimeter.. This will be signalled acoustically and
the display will show current water temperature.
Set up water temperature using "+" and "-" buttons. Pre-set water temperature is 100
kettle is switched on, the kettle will boil water.
Switch-on the kettle by pushing the switch.
Kettle's light indicator will be visible throughout the entire cooking time, and the display will show water temperature.
After the water boils, the kettle will automatically switch off . Light indicator will go out and also acoustic signal will be emitted.
Raise the kettle from the base by grasping the handle only.
It is not necessary to open the lid for pouring water.
Unplug the power cord from the mains socket.
After the use, leave the product to cool down.
O R I G I N A L
GB
C. If no other temperature is set before the
o
I N S T R U C T I O N S
11