Publicidad
Idiomas disponibles
Idiomas disponibles
Rangetop
may discolor or chip without cookware to absorb the heat.
Lighting the Rangetop
WARNING
Burners should be operated only
clothing ignition. Never let flames extend beyond the
in serious injury.
the appropriate burner control knob counterclockwise to
the HI position. Sparking will continue as long as the knob
remains pressed. Once the burner is lit, release the knob
and rotate to adjust the flame.
Selecting a Flame Size
Watch the flame, not the knob, as you adjust heat. When
rapid heating is desired, the flame size should match the
size of the cookware you are using. Flames larger than
the bottom of the cookware will not heat faster and may
be hazardous.
Lighting the Rangetop Manually
If a rangetop burner fails to ignite, you may light the
burner manually by following the steps below:
burner control knob
counterclockwise to the HI
position.
2. Immediately strike and
place a burning long
wooden match or a gas
lighter near the burner to
light.
If the Flame Goes Out
Immediately turn the control knob to OFF position. Wait
at least 5 minutes and light the burner again.
49-2001154 Rev. 0
turn it to the HI position.
turn it to the HI position.
These flames are too large for the pot
3. Rotate the burner
control knob to
adjust the flame
level.
4. Repeat steps
needed.
Turning Off the Rangetop
To turn the rangetop burners off, rotate the control knobs
objects on the grates until the rangetop has cooled.
Publicidad
