Clean and Maintenance
1
Open panel
Pull out the panel to a certain
angle as shown in the fig.
2
Remove the filter as in-
dicated in the fig.
The filter should be cleaned every three months. If there is much dust in the
operation environment, clean frequency can be increased.
After removing the filter, do not touch fins to avoid injury.
Do not use fire or hair dryer to dry the filter to avoid deformation or fire hazard.
3
Use dust catcher or water to
clean the filter.
When the filter is very dirty, use
the water (below 45
it, and then put it in a shady
and cool place to dry.
4
Install the filter and then close the
panel cover tightly.
27
) to clean
GB