Sony CSM-20S Manual página 17

Installing the S-AIT
Library
The S-AIT library weights about 27 kg /59.5 lbs. (with a
single drive installed) and has the following dimensions.
With two drives installed, the S-AIT library weighs
approximately 31 kg/68.3 lbs. Make sure that the surface
where you will install the S-AIT library is appropriate
before installing the unit.
430 mm
(16.9 in.)
With the rack mounting kit (sold separately), the S-AIT
library can be installed on an EIA STANDARD
(universal pitch) 19-inch rack. Contact your dealer for
information about the rack mounting kit.
Note
Install the S-AIT Library on a horizontal surface near an
AC power outlet. Make sure that you leave gap of about
150 mm (5.9 in.) behind the rear of the unit to allow air
to circulate.
Front
430 mm (16.9 in.)
745 mm (29.3 in.)
About 760 mm (29.9 in.)
(To cooling fans)
220 mm
(8.7 in.)
745 mm (29.3 in.)
50 mm (2.0 in.)
Rear
150 mm
(5.9 in.)
50 mm (2.0 in.)
Recommended positioning of the unit
• Always position the unit horizontally.
• Away from moving air, such as fans, open windows, or
air conditioners.
• Away from devices such as facsimiles to avoid toner
and paper dust.
Caution
• The S-AIT library should not be stacked. Do not place
anything on top of the unit.
• Do not place the S-AIT library in locations subject to
rapid temperature changes. This could cause
condensation to form inside the library, leading to
malfunctions.
17
Installing the S-AIT Library