Trust START-LINE ACC-250-LD Manual Del Usuario página 6

EN
ACC-250-LD COMPACT WIRELESS SOCKET DIMMER
1. Place the socket dimmer
A
Connect your lighting to the dimmer and plug the
dimmer into a power outlet.
B
The socket dimmer will activate the pairing mode for
about 6 seconds and the LED on the socket dimmer will
blink green.
2. Pair the socket dimmer with a transmitter
A
After plugging in the socket dimmer, send an ON signal
(during the pairing mode) with a Trust Smart Home
transmitter.
B
The lighting goes on and off 2x to confirm that the
pairing has succeeded. The LED on the dimmer will also
flash quickly and then go off. The dimmer can store
up to 32 different channels in the memory. The paired
transmitters will be remembered when the socket
dimmer is moved to another power outlet.
3. Operating the socket dimmer
A
Press the ON button with the assigned channel on the
paired transmitter to turn the lighting ON. Press the
OFF button with the assigned channel on the paired
transmitter to turn the lighting off.
4. Manual On/OFF switch
With the ACC-250-LD you can manually switch your light
ON or OFF by pressing the button on the housing.
6
5. Activate dimming sequence
• Press the ON button on the transmitter to turn the
receiver on.
• Press ON again to activate the dim sequence.
• Press ON a third time to lock the desired dim level
The dim sequence will stop and automatically lock the dim
level at the highest or lowest point when no input is given
with a transmitter.
6. Adjust the dimming range
If the connected LED lighting does not dim deep enough
or vibrate, you can adjust the lower limit of the dimming
range.
Press the ON button on the transmitter to turn the
receiver on.
A
Press and hold the button on the housing (ca. 3 sec)
until the LED flashes twice. You can now adjust the
dimming range. The mode to adjust the dimming range
lasts for 30 seconds.
B
Press the OFF button on a paired transmitter to
increase the dimming range one step. The connected
LED lighting will then become less bright, so the
dimming range will increase. In order to reduce the
dimming range with one step, press the ON button to
make the lighting more bright.
C
Press the button on the housing shortly to set the
selected dimming range. The LED flashes quickly and
your light goes on and off twice to confirm the dimming
range.