Descargar Imprimir esta página

Trust START-LINE ACC-250-LD Manual Del Usuario página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
7. Select dimming mode
If your lighting vibrates, you can choose a different
dimming mode.
A
Press the ON button on the transmitter to turn the
receiver on.
B
Press and hold the button on the housing (ca. 10 sec)
until the LED flashes 4 times fast.
C
Press the button on the housing shortly to switch
to leading or trailing edge dimming. The LED on the
housing flashes quickly and your lighting goes on and
off 2x to confirm the selected dim mode.
With leading edge, the LED will light up 1x when the
dimmer is switched on or off. With trailing edge, the
LED will blink 2x when the dimmer is switched on
or off.
RLC (Leading edge): Dimmable incandescent-, halogen-,
LED -lamps and lamps with a traditional (wound coil)
dimmable transformer
RC (Trailing edge): Dimmable incandescent-, halogen-,
LED -lamps and lamps with an electronic dimmable
transformer
Should your lighting still vibrate then check whether
your lamp is dimmable or try another dimmable lamp.
ACC-250-LD COMPACT WIRELESS SOCKET DIMMER
.
Optional: Unpair the socket dimmer from a
transmitter
A
Remove the socket dimmer from the power outlet. Plug
the socket dimmer back in the power outlet. The pairing
mode will be activated for about 6 seconds and the
green LED will blink.
B
While the pairing mode is active, send an OFF signal
with the assigned channel on the paired transmitter
to unpair it.
C
The lighting goes on and off 2x to confirm that the
unpairing has been successful. The LED on the dimmer
will also flash quickly and then go off.
Optional: Clear the memory of the socket dimmer
A
Remove the socket dimmer from the power outlet. Plug
the socket dimmer back in the power outlet. The pairing
mode will be activated for about 6 seconds and the
green LED will blink.
B
While the pairing mode is active, send an GROUP
OFF signal with the assigned channel on the paired
transmitter to unpair it.
C
The lighting goes on and off 2x to confirm that the
unpairing has been successful. The LED on the dimmer
will also flash quickly and then go off.
EN
7

Publicidad

loading

Este manual también es adecuado para:

71167