Publicidad
Idiomas disponibles
Idiomas disponibles
6. Install the Remote Control Dock
Remove and retain the screw from the cover of the remote control dock.
Twist the cover to disengage from the dock.
Position the docking station at the desired mounting location.
Using a pencil, mark the two mounting-hole locations.
For installation into a stud or other wood surface: Drill a 1/16" (2 mm) hole at each of the marked locations.
For installation using wall anchors: Drill a 1/4" (6 mm) hole at each of the marked locations. Install the provided wall
anchors into the holes.
Position the docking station over the anchors or marks. Secure with the provided screws.
Install the three provided AAA batteries in the compartment on the back side of the cover. Make sure that the batteries
are oriented as shown.
Reinstall the cover onto the dock and secure with the screw.
Place the remote control on the docking station. Make sure that the charging ports engage the pins on the dock.
Once charged, the remote control should automatically pair with the toilet. If the remote control loses connection with
the toilet, refer to the "Remote Control - Setup" section for pairing instructions.
Kohler Co.
Charging
Pins
AAA
Batteries
9
1411744-2-E
Publicidad
