Publicidad
Idiomas disponibles
Idiomas disponibles
Stainless steel should be cleaned regularly (eg weekly) to ensure a
long service life. Dry with a soft and clean cloth. A specialized
stainless steel cleaning fluid can be used.
The filters can be cleaned by hand. Soak them for about 3 minutes
in water with a detergent that releases grease and then rub it gently
with a soft brush. Do not apply too much pressure, avoid damaging
it. (Allow it to dry naturally out of direct sunlight)
The filters should be washed separately and should not be mixed
with crockery and other kitchen utensils. It is recommended not to
use rinse aid.
In order to install the filters again, please consider the following
notes:
• Angle the filter into slots at the back of the hood.
• Push the button on handle of the filter.
• Release the handle once the filter fits into a resting position.
• Repeat to install all filters.
REPLACING THE BULB
Consider below notes to replace the bulb:
1. Switch off the appliance and unplug it.
2. Slide the front part of the cooker hood.
3. The al filter should be detached first. Press the lock and pull it
downward.
4. Replace with same type of light.230V~50Hz, MAX.2.5W LED
ILCOS D code for this light is DBS-2.5 / 65-H-120/33.
• Maximum power: 2.5W
• Voltage: AC 230V
• Dimensions
27
Publicidad
