Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan Blades
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1.
Position blade along the motor, aligning blade holes
with holes in the top of the motor assembly flywheel.
Make sure the blade is fully seated against the
flywheel and tighten 3/16˝-24 truss head screw with
spring washer/flat washer, but don't fully tighten at
this time. (Figure 1)
Install and securely tighten 3/16˝-24 truss head
2.
screw with spring washer/flat washer at the underside
of the blades, then securely tighten all previously
installed screws on top of motor. (Figure 2)
3/16˝-24
Truss Head Screw
With Spring Washer/
Flat Washer
9
Motor
3/16"-24
Truss Head Screw
With Spring Washer
/Flat Washer
(2 each per blade)
Figure 1
Blade
3/16"-24
Truss Head Screw
With Spring Washer
/Flat Washer
(2 each per blade)
Figure 2
HARDWARE USED:
X
Blade
20
Publicidad
