Publicidad
Idiomas disponibles
Idiomas disponibles
■
Do not use a battery pack or tool to fire or
excessive temperature. Exposure to fire
or temperature above 130°C may cause
explosion.
■
Follow all charging instructions and do not
change the battery pack or tool outside the
temperature range specified in the instructions.
Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
SERVICE
■
Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
■
Never service damaged battery packs.
Service of battery packs should only
be performed by the manufacturer or
authorized service providers.
CORDLESS SHREDDER SAFETY
WARNINGS
■
While setting up the product for use, make
sure that the product is secured so that it
does not tip over. If the product is turned
off too quickly, remaining pieces of material
may clog the blade assembly and stall the
motor when the product is turned back on.
■
Before starting the product, look into the
feeding chamber to make sure that it is
empty.
■
Keep your face and body away from the
feed intake opening.
■
Do not allow hands or any other part of the
body or clothing inside the feeding chamber,
discharge chute, or near any moving part.
■
Always be sure of your footing. Keep firm
footing and balance at all times. Do not
overreach. Never stand at a higher level
than the base of the product when feeding
material into it. Walk, never run.
■
Always stand clear of the discharge zone
when operating the product.
■
When feeding material into the product,
be extremely careful that pieces of metal,
rocks, bottles, cans, or other foreign objects
are not included.
4
Original Instructions
■
If the cutting mechanism strikes any foreign
objects or if the product should start making any
unusual noise or vibration, turn off the product
and allow the cutters to completely stop. Remove
the battery pack. Perform the following steps:
●
Inspect the product for damage.
●
Check and tighten any loose parts of the
product.
●
Replace or repair any damaged parts.
■
Do not allow processed material to build up
in the discharge chute as this may prevent
proper discharge or blockage and can result
in kickback of material through the feed
intake opening.
■
If the product becomes clogged, turn off the
product and allow the cutters to completely
stop. Remove the battery pack before
clearing debris.
■
Never operate the product if the guards,
covers, collection box, or other safety
devices are defective, not in place, and not
in good working order.
■
Do not move or transport the product while
the product is running.
■
Turn off the product and remove the battery
pack. Make sure that all moving parts have
come to a complete stop:
●
before leaving the product unattended
●
before clearing a blockage
●
before checking, cleaning, or working on
the product
■
Do not tilt the product while it is running.
■
Injuries may be caused, or aggravated, by
prolonged use of the product. When using
the product for prolonged periods, ensure to
take regular breaks.
■
Do not modify the product in any way or use parts
and accessories that are not recommended by
the manufacturer. This may increase the risk of
serious injury to yourself or others.
■
Always ensure that the ventilation openings
are kept clear of debris. The motor may
overheat resulting in possible damage to
the product or increase the risk of fire.
■
Turn off the product before attaching or
removing the collection box.
■
Immediately turn off the product and remove
the battery pack in the event of accident
or breakdown. Do not operate the product
again until it has been fully checked by an
authorised service centre.
Publicidad
