STERWINS UP20 Instrucciones De Montaje página 208

FR
7. MAINTENANCE
7.1 CLEANING
ES
PT
Cleaning the product: illustration 5.1 to 5.8
Let the machine cool for 2 hours outside before cleaning it. Remove the guide bar and the
IT
saw chain. Clean the cover plate with a brush. Clean the area under the cover plate, the drive
sprocket and chain bar assembly using a soft brush. Clean oil outlet with a dry cloth.
Keep all safety devices, air vents, and motor housing free of debris and dirt. Wipe down the
EL
equipment with a cloth. It is highly suggested that you clean the device after every use. Do not
use cleaning agents, as these can attack the plastic and weaken the structural integrity of the
product.
7.2 REPLACEMENT
PL
When servicing, use only identical replacement parts. Use of any other parts may create a
hazard or cause product damage. If you shall replace the cutting blade, make sure that the
following characteristics are the same : same shape, same length, same thickness, same
RU
weight, same material.
The following part of this product may be replaced by the consumer.
→ Saw chain
KZ
→ Guide bar
Other spare parts are available at an authorised dealer or through our customer service.
UA 7.3 MAINTENANCE SCHEDULE
Part
RO
EN
Chain
Guide Bar
WARNING ! DO NOT HANDLE CUTTING PARTS WITHOUT GLOVES
AS THEY ARE SHARP AND CAN BECOME HOT AFTER USE,
POTENTIALLY CAUSING PERSONAL INJURY.
Action
Check
Clean
Change
Sharp
Check
Clean
Change
After each
Oil
208
Before/
Every
10H
usage
When it's necessary / Refer
to trouble shooting
When it's necessary / Refer
to trouble shooting
Every
2Y