STERWINS UP20 Instrucciones De Montaje página 211

Problems
The motor stops
while operating
The Motor is ON,
blades do not move
Machine suddenly
stopped while
cutting branches.
Product does not
reach full power
Vibration or noise
is excessive
Probable causes
thickness of branches
exceeds capacity
Wood or material too
hard for the machine or
blade is not adapted
The battery is discharged
The machine has damage
The blades are blocked
the Motor maybe
occur overload
the Motor maybe
occur overheat
the Battery maybe
occur overheat
The battery is discharged
Battery pack
capacity too low
Air vents are blocked
Bolts/nuts are loose
The machine has damage
211
Solutions
only cut branches
complying with
the capacity
only cut material
complying with the
capacity and with
a blade adapted
to the work
Recharge the battery
Do not use the
machine and speack
to service center
Turn off the motor
then clear blockage
from the blades
Stop the machine
and wait for 3
minutes to restart.
Stop the machine
and wait for the
engine to cool before
switching it on again.
Stop the machine
and wait for the
battery to cool before
switching it on again.
Charge the battery
according to the
instructions included
with your machine
Charge the battery
according to the
instructions included
with your machine
Clean the air vents
Tighten bolts/nuts
Do not use the
machine and speack
to service center
Qualification
-
Approved
repair centre
-
RU
-
RO
EN
-
-
Approved
repair centre
FR
ES
PT
IT
EL
PL
KZ
UA