Atlas Copco ETV STR61-100-13 Instrucciones Del Producto página 5

Idiomas disponibles

ETV STR61-100-13

Installation

Installation requirements

Installation

Connecting tool

The tool should, via its correct Power Focus drive unit, be connected to the

mains, 230V/50Hz alternatively 115V/ 60Hz, single phase. See instructions for

your Power Focus drive unit.

Tool display

The tool display is turned on from the controller.

On Power Focus 4000:

• Push the Prog button

• Use the navigation buttons to follow the path > Tool > Configuration > Ac-

cessory bus > ST bus > Mode

Socket release function

It is recommended to use the socket release function on all the ETP ST101

tools. When the function is enabled, the socket rotates backwards 3

completed tightening. The aim is to reduce tension on the reaction bar and to

make it easier to remove the tool.

The socket release function is turned on from the controller.

On Power Focus 4000:

• Push the Prog button

• Use the navigation buttons to follow the path > Pset > Programming+ > Op-

tions > Socket release > Mode On

Installing accessories

Fitting of the tool cable

• Security check that the cable type is correct

• Align the cable connector using the two asymmetrically positioned heads on

the connector to fit in the slots in the tool handle.

• Tighten the lock nut.

• Security check that the connection is correct by pulling, pushing and turning

the cable connector (there should be no movement).

The tool has a built in electronic memory chip that will transmit the torque

transducer calibration value and angle pulses to the POWER FOCUS/drive

unit. Any changes made of these values in the POWER FOCUS while the

tool is connected will be stored in the tool memory.

after a

Installation