Outsunny 840-239V00 Manual Del Usuario página 15

If a mallet is necessary for installation, we recommend placing the nut on
the screw (loosely)before hammering to avoid damaging the bolt threads.
3. Make sure that the bolts are firm in place, yet let them stick out of the wall
approximately 2.5 cm or less-enough that the wall bracket can be installed onto
them. Firmly tighten the bolts with a 17 mm hex key. It is best to use the hex key with
a closed end rather than an open end to avoid damaging the nut, should it slip.
M10X80MM
Expansion bolt
7.Please assemble the A1on
the wall by first, tighten the
bolts by wrench.
8.Then insert the left side of the roller bar into A1 hole.
9. After installation on the left
side,insert right side of the roller bar
into the A2 hole, then tighten the
bolts using a wrench.
Spring washer
bolt
washer
14