Outsunny 840-239V00 Manual Del Usuario página 21

Step3: Don't forget to tighten the screws( I &2)
after adjusting the inclination of the awning.
If you don't tighten the screw( 1 &2), the screw 3
will be damaged soon.
Stepl:Hold up the arm and loosen the screw( 1
&2) Don't loosen the screw directly without
holding the arm up.
Step2: Keep holding up the arm(C2)by your hand
and adjust the screw(3)
If you turn the screw in the direction of arrow a,
the angle of the awning will go down.
If you turn the screw in the direction of arrow b,
the angle of the awning will rise upward.
After adjusting the screw3, please check if the
awning has been adjusted to the proper angle,if
not,please repeat the above installation steps 2
until the angle is suitable.
Step3:Don't forget to tighten the screws( 1 &2)
after adjusting the inclination of the awning.
If you don't tighten the screw( 1&2), the screw 3
will be damaged soon.
20