Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 15 Thursday, December 22, 2022 4:06 PM
CAUTION
• Connect the dishwasher to a hot water supply
with a temperature range between 120 °F (49 ℃)
and 149 °F (65 ℃). This temperature range
provides the best washing results and shortest
cycle time. To prevent damage to dishes, the
temperature should not exceed 149 °F (65 ℃).
• Water supply pressure must be between 20 psi
and 80 psi (140–550 kPa). If the water supply
pressure exceeds 80 psi, a pressure reducing
valve must be installed. Otherwise premature
failure of the inlet valve may occur.
Connecting Water Supply Line and
Power
Water supply tube: Minimum 3/8" O.D. copper
tubing or metal braided dishwasher supply line
1
Connect the elbow
a
back of the dishwasher.
2
Connect the water supply tube to the elbow.
3
Tighten both connections using two
adjustable wrenches to avoid putting stress
on the water inlet valve.
4
Make sure the water supply is turned off.
Connect the water supply tube to the tap.
to the inlet valve on the
5
Insert the power plug into an outlet.
6
Turn on the water and check for leaks at the
connections.
• If there is a leak, reconnect the elbow.
• Do not cross thread or overtighten the
connections to avoid leakage.
7
Unplug the power cord.
8
Turn off the water supply and disconnect the
water supply tube at the tap.
Sliding Dishwasher into
Cabinet Opening
How to Slide Dishwasher
CAUTION
• Do not pull or lift the dishwasher using the door
. Doing so can damage the door and hinges.
a
INSTALLATION
15
Publicidad
