Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 20 Thursday, December 22, 2022 4:06 PM
20 INSTALLATION
Adjusting Rear Leveling Foot
Use a Phillips screwdriver to adjust the rear
leveling foot and the rear of the tub using the
center screw at the base of the appliance in the
front.
• Turn the center screw clockwise to raise the rear
of the tub and counterclockwise to lower it.
NOTE
• To avoid damaging the screw, do not use an
electric screwdriver.
Securing Cabinet Panel to
Dishwasher
Adjusting Appliance Height
1
Adjust the height of the appliance so the top
of the door is as close to the height of the
surrounding cabinet doors or drawer fronts
as possible.
2
Measure the difference in height (x") between
the top of the dishwasher door and the tops
of the surrounding cabinet doors or drawers.
X (m m )
(m m )
X " In ch
3
Using the measurement from step 2, make a
mark x" up from the bottom of both rulers at
the top of the provided installation template.
Draw a line between the marks and trim off
the top of the template at the line. Cut out the
squares marked on the midline of the
template so that you can see the center line.
(X mm)
Adjusting Door Spring Tension
If the cabinet panel weighs between 17.6 lb (8 kg)
and 24.2 lb (11 kg), adjust the door spring tension
to make the door easier to open.
17.6 lb (8 kg) ≤
1
Open the dishwasher door to about 30 °.
• Do not adjust the spring strength with the
dishwasher door fully open.
2
Use the door adjustment screws provided to
adjust the door spring tension at the bottom
of the dishwasher.
X "
≤ 24.2 lb (11 kg)
Publicidad
