EINHELL GP-LC 36/35 Li Manual De Instrucciones página 20

11. Troubleshooting
Danger!
Before troubleshooting, switch off the equipment and pull out the batteries.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If the problem still persists after working through the list, please
contact your nearest service workshop.
Problem
Chain saw does not
work at all.
Chain saw operates
intermittently.
Saw chain is dry.
Chain brake does
not work.
Chain/guide bar
is hot.
Chain saw judders,
vibrates or does not
saw properly.
Anl_GP_LC_36_35_Li_SPK7_USA.indb 20 Anl_GP_LC_36_35_Li_SPK7_USA.indb 20
EN
Possible cause
- Chain brake has been triggered.
- No power supply.
- Loose On/Off switch defective.
- No oil in the tank.
- Vent in the oil tank cap is blocked.
- Oil outlet is blocked.
- Problem with the switch mechanism
in the front hand guard.
- No oil in the tank.
- Vent in the oil tank cap is blocked.
- Oil outlet is blocked.
- Chain is blunt.
- Chain is undertensioned.
- Chain is blunt.
- Chain is worn.
- Saw teeth pointing in the wrong
direction.
- 20 -
Solution
- Pull the chain brake to the normal
position.
- Check the batteries.
- Consult a service center.
- Top up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Consult a service center.
- Top up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Refi t the chain with the teeth facing
in the correct direction.
05.12.2022 11:14:46 05.12.2022 11:14:46