Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
OPERATION INSTRUCTIONS
1. POWER
Power display is always on. In STANDBY mode, the display will turn on for 3s and turn
off with only the POWER indicator light on. The default running operation is 50%RH on
Low fan speed. When operating a PRESET mode, the machine will resume the previous
operating function when switched off and on. During auto operation (four LED lights
in Auto mode are off), the unit will automatically turn off and enter STANDBY mode.
After resuming from STANDBY, the system will reset to the Auto mode 50% with low
fan speed.
2. FAN SPEED
Press "FAN SPEED" button as follows:
When the fan speed needs to be adjusted, press the fan speed button to adjust the
Low, Mid and High fan speed. When the corresponding indicator light is on, the current
speed has been set.
3. "UP" and "DOWN"
Press "UP" and "DOWN" to enter the Auto dehumidification operation. The humidity is
set to 35%-- 80%, with 5%RH added and decreased each time.
4. MODE
Press "MODE" to select the Preset Mode: Sleeping Area (55%), Living Space (50%),
Basement (45%), Continuous switch the sequential cycle, and the corresponding mode
indicator light is on.
5. TIMER
Press "Timer" button to set the timer up to 24 hours.
(1) In startup state, press the Timer button to set the startup function. The Timer light
will be on, and the display will initially display 0.5. Press "UP" and "DOWN" to adjust
the time. The timer indicator is on when the timer function is active. Press the Timer
key again to cancel the timing function.
(2) In the shutdown state, press the Timer button to set the shutdown function. The
display will show "0.5" on the control panel as default. At this point, press the "UP"
and "DOWN" keys to adjust the timing time.
(3) The range of time is 0.5h-24h. Press "UP" and "DOWN" to adjust ±0.5h between
0.5h-10h, while ±1h between 10h-24h.
6. FILTER
Reset the "Filter" key:
After the dehumidifier starts up and runs for 250 hrs. the indicator light for cleaning the
filter screen will be on. Refer to CLEANING & CARE section for Filter instructions. After
filter has been cleaned, press the FILTER button to remove the indicator light and reset
the timer.
7. PUMP (Only with model CCD50PJW)
Press the button to enter the PUMP function, the PUMP indicator light is on, press
again, exit the function, and the PUMP indicator light is off; (Before starting the pump,
it is necessary to install the pump detection device. At this time, the DRAIN TUBE
CONNECTED light is on.)
Page 10
Publicidad
