Commercial Cool CCD25JW Manual Del Usuario página 13

SET UP & USE
3. When replacing the drainage tank, press the tank firmly into place with both hands.
If the tank is not positioned properly, the "BUCKET FULL" sensor will be activated,
and the dehumidifier will not operate.
IMPORTANT NOTES:
Placing the dehumidifier on an uneven surface or improper hose installation may
result in water filling up the tank and cause the unit to shut off. Empty tank if shut-off
occurs, then check dehumidifier location and hose for proper setup. The tank must be
in place and securely seated for the dehumidifier to operate.
Option 2: Continuous drainage
Water can be automatically emptied by attaching the drain hose (included) to the
drain port on the back of the dehumidifier. This will allow the unit to run continuously
(depending on the selected humidity level) without having to empty the unit's water
collection bucket. To install the included Drain Hose Kit, remove the drain cap on the
back of the unit. Insert the included drain hose adapter and turn clockwise, Insert the
Drain Hose onto the Drain Adapter.
Once securely installed, lead the drain hose to a nearby drain lower than the height
of the drain plug. (Make sure there are no kinks or knots in the hose). Turn on the unit
and press the MODE button until set to CONTINUOUS. This will allow the unit to run
continuously (depending on the selected humidity level) without having to empty the
water bucket.
Drain Hose Adapter Storage Compartment
Drain Hose Adapter
Drain Hose
Page 13