Publicidad
Idiomas disponibles
Idiomas disponibles
To do a check of the ON/OFF buttons of the blastmotor
1. Set the ON/OFF switch on the electrical enclosure to
the ON position.
2. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
3. Start the control panel.
4. Push the ON button (A) on the electrical enclosure
and make sure that the motor starts.
5. Push the OFF button (B) on the electrical enclosure
and make sure that the motor stops.
Ammeter
The ammeter shows the blast load onto the surface. The
maximum amperage is shown above the ammeter.
To do a check of the ammeter
Electrical enclosure and control panel overview
Refer to
on page 5 for information about where the ammeter is
on your product.
1. Start the product. Refer to
page 18 .
2. Wait until the ammeter is in idle position.
2070 - 003 - 16.03.2023
A
B
To start the product on
3. Stop the product. Refer to
page 21 .
Emergency stop button
The emergency stop button is used to quickly stop the
motors.
To do a check of the emergency stop button
Electrical enclosure and control panel overview
Refer to
on page 5 for information about where the emergency
stop button is on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 18 .
3. Push the emergency stop button.
4. Make sure that the motor stops.
5. Turn the emergency stop button clockwise to
disengage.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Do the maintenance of the product on stable level
ground. Make sure that the product cannot move.
•
Do not make modifications to the product.
Modifications that are not approved by the
manufacturer can cause serious injury or death.
•
Replace damaged, worn or broken parts.
•
Do not use a pressure washer to clean the product.
•
Only use lint-free cleaning cloths.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
•
Let an approved service agent do servicing on the
product regularly.
To stop the product on
To start the product on
Read the warning
11
Publicidad
