Publicidad
Idiomas disponibles
Idiomas disponibles
General product maintenance
Make sure that the dust extrac-
tor hose is not damaged and
that there is no blockage.
Empty the dust extractor.
Do a check of the of the abra-
sive separator, the separator
tray and the feedspout.
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush seal
and magnetic seal for wear.
Do a check of the control cage,
blastwheel and liners for wear.
To do before you oper-
Refer to
ate the product on page 12 .
Do a check of the drive belt ten-
sion.
Do a check of the drive chain
tension of the drive system.
Clean the drive chain of the
drive system.
Do a complete servicing and
cleaning of the product.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To clean the chain of the drive system
1. Remove dirt on the outer surface of the chain with a
hard brush or wire brush.
2. Clean the chain with cleaning agent.
3. Remove dirt from internal parts of the chain.
2070 - 003 - 16.03.2023
Each 3 h
Daily
*
*
X
X
X
X
X
X
12 h after
service
To remove and install the control cage
1. Remove the 2 screws, the 2 washers and the feed
spout.
Each 3
Yearly
months
X
X
X
O
23
Publicidad
