Publicidad
Idiomas disponibles
Idiomas disponibles
Shutting Off the Hedge
Trimmer
To shut off the hedge trimmer, release the run trigger
(Figure
8). Allow at least 5 seconds for the cutting
blade to stop moving.
Whenever you are not using the trimmer or are
transporting the trimmer to or from the work area,
remove the battery pack and install the blade cover.
Removing the Battery Pack
from the Power Head
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine
(Figure
10).
Figure 10
1. Battery latch
Removing the Attachment
from the Power Head
1.
Ensure that the battery pack is removed from
the power head; refer to
Pack from the Power Head (page
2.
Loosen the screw-handle on the shaft connector
(Figure
3).
3.
Press the locking button down while pulling the
2 shafts apart
(Figure
g357457
Removing the Battery
12).
3).
Operating Tips
•
Use the power tool for cutting in either direction in
a slow, sweeping action from side to side.
•
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
cutting blade.
•
Use a non-powered hand saw or pruning saw to
trim stems that are too large.
•
If desired, you can use a string to help cut your
hedge level. Decide how high you want the hedge.
Stretch a piece of string along the hedge at the
desired height. Trim the hedge just above the
guide line of string.
12
Publicidad
