Descargar Imprimir esta página

Toro 88713 Manual De Instrucciones página 15

Ocultar thumbs Ver también para 88713:

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
After each use of the trimmer, complete the following:
1.
Remove the battery pack from the trimmer
before maintaining or cleaning.
2.
Wipe the trimmer clean with a damp cloth any
time there is an accumulation of debris. Do not
hose the trimmer down or submerge it in water.
WARNING
The hedge trimmer blades can cause
cuts or amputation.
Be careful when handling the hedge
trimmer with the protective cover
removed.
3.
Inspect the machine, check and tighten all
fasteners. If any part is damaged or lost, repair
or replace it.
Important:
Use only the manufacturer's
recommended replacement parts and
accessories.
Have the product repaired only by an
Authorized Service Dealer.
4.
Brush debris away from air intake vents and
exhaust on motor housing to prevent the motor
from overheating.
Greasing the Hedge
Trimmer
Service Interval: Every 10 hours
Grease Type: Lithium–based grease.
1.
Place the hedge trimmer on a flat surface and
remove the battery pack; refer to
Battery Pack from the Power Head (page
2.
Clean the grease fittings with a rag
3.
Connect a grease gun to each of the fittings and
pump grease into the fittings until grease flows
out from the fittings.
4.
Wipe up any excess grease.
1. Grease fitting locations
Lubricating the Blades
Service Interval: After each use
The hedge trimmer blades can cause cuts or
amputation.
Be careful when handling the hedge trimmer
with the protective cover removed.
1.
2.
3.
Removing the
12).
(Figure
11).
1. Apply machine oil to the top edge of the blades.
13
Figure 11
WARNING
Shut off the trimmer, remove the battery pack,
and place the trimmer on a flat surface.
Clean dirt and debris from the hedge trimmer,
using a brush or a damp cloth with a mild
detergent.
Apply light weight machine oil (such as #10)
along the edge of the top blades
Figure 12
g363854
(Figure
12).
g428369

Publicidad

loading