Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
Safety Information
If installing into ceramic tile, before attempting to
through ceramic tile, the following must be done:
a. Using a center punch, very lightly and carefully tap
the spot where you wish to drill to break the shiny glass
portion of the tile.
b. Once this is done you can safely drill through the tile
with a standard masonry drill bit and install a standard
masonry anchor (FF).
4
Installing the bracket in ceramic
tile
Drill a 1/4 in. pilot hole at each pencil mark made.
Tap 1/4 in. masonry wall anchors (FF) into the
wall with a hammer until flush with the wall.
Align the mounting bracket (BB) with installed
masonry wall anchors (FF) and secure with the
mounting screws (CC).
6
Installing the towel bar
Slide each end of the bar (1) into the two posts
(2).
Attach the towel bar to the mounting bracket
(BB) using the set screws (EE). Tighten securely
with the Hex wrench (DD).
FF
BB
5
Installing the bathroom accessory
drill
NOTE: If you are hanging the towel bar, proceed to Step 6
Position the bathroom accessory over the mounting
bracket (BB) and attach using the set screw (EE).
Tighten securely with the Hex wrench (DD)
DD
CC
2
EE
5
Please contact 1-855-HD-GLACIER for further assistance.
EE
EE
2
BB
DD
HOMEDEPOT.com/GLACIERBAY
DD
1
Publicidad
