Audio Settings - Pioneer DEH-X5800HD Manual De Instrucciones

Menu Item
HD SEEK*
[ON], [OFF]
BLEND*
[ON], [OFF]
ACTIVE RADIO
[ON], [OFF]
S.RTRV
USB iPod
[1] (effective for low compression
rates),
[2] (effective for high
compression rates),
[OFF]
AUDIO BOOK
iPod
[FASTER], [NORMAL], [SLOWER]
BOOKMARK
NEW STATION
[FROM TRACK], [FROM ARTIST]
PAUSE
* If [HD SEEK] is set to [ON] and [BLEND] is set to [OFF], the tuner cannot receive broadcasts. In this
case, [HD SEEK] or [BLEND] is changed automatically as follows:
Description
Change seek tuning setting between digital
station seek ([ON]) and all station seek ([OFF])
depending on the reception status.
Set [ON] to switch to the analog broadcast of the
same frequency level automatically if a digital
broadcast reception is poor. Set [OFF] to receive
analog broadcast only.
Interrupt the currently selected source with
emergency announcements or test messages. A
beep can be heard when an emergency
announcement or test message breaks in. Select
[OFF] to disable this function. (In some cases
when a test message is received, a notification
will appear in the display instead of a beep.)
Enhance compressed audio and restore rich
sound.
Not available when:
• USB is selected as a source and the MIXTRAX
function is set to on.
• CD-DA/CD-TEXT is played back.
Change the playback speed. (Not available when
[CONTROL iPod] is selected in the control mode.)
Store the track information currently being
played in your Pandora account.
Create a new station based on the track or artist
currently being played.
Pause or resume playback.
– When [HD SEEK] is set to [ON], if you switch [BLEND] from [ON] to [OFF], [HD SEEK] is changed to
[OFF].
– When [BLEND] is set to [OFF], if you switch [HD SEEK] from [OFF] to [ON], [BLEND] is changed to
[ON].

AUDIO settings

Menu Item
FADER*1
BALANCE
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM1],
[CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level: [+6] to [–6]
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
Description
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
• USB, iPod, PANDORA (iPhone), ANDROID, and
APP (iPhone)
[CUSTOM2] is a shared setting used for all
sources.
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
11
En