Kenwood UBZ-LH68 Manual De Instrucciones página 26

To set the lamp continuously ON:
1
2
3
4
Note:
◆
The APO function {page 25} will override the continuous lamp setting.
When APO turns OFF the transceiver, it will also turn OFF the lamp.
However, the lamp setting will remain and the lamp will again turn ON
when the power is turned ON.
◆
The amount of power consumed with lamp continuously ON is
slightly more than with lamp OFF.
20
With the transceiver power OFF, press
and hold the UP key, then press the
POWER switch.
Press the UP or DOWN key to select
"LP" (Menu No. 4).
Press the MODE key to switch the
function ON (or OFF).
Press the PTT switch to exit Menu
mode.