Samoa PM45 Manual Del Usuario página 4

EN
DESCRIPTION
Compressed air powered reciprocating piston pump. This high capacity
demand pump is compatible with mineral and synthetic oils and
INSTALLATION
This pump can be mounted directly on the wall, using the
bracket (360132). Firmly fix the bracket to the wall. Put the pump on it
and fix with included screws (Fig. 1).
In those cases in which it is required to comply with ATEX conditions,
be sure to ground the pump with the cable equipped with
a clamp (534907).
TYPICAL INSTALLATION
Please see figure 2, a typical installation shown with all the recommended
accesories for the pump to operate correctly.
NOTE: The compressed air supply must be between 2 to 12 bar (40 to
180 psi), and 6 bar (80 psi) is ideal.
POS. DESCRIPTION
Ball Valve,
A
Low Pressure
B Filter/Regulator
C Air hose
D Quick coupling
E Connection nipple
F Pump
G Pressure Relief Valve
H Oil hose
I Ball Valve, Medium Pressure
J Wall bracket
K Oil suction hose
L Ball Valve, Low Pressure
OPERATION
This pump is self–priming. To prime it the first time, you must connect
the air supply to the pump and slowly increase the air pressure from 0
to the desired pressure using a pressure regulator.
4
853 802 R. 03/23
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
PART NO.
950319+
239004
241001
362100
251412
255312
536330
609008
Fig. 2
362303
950303
360132
367003
950306
suitable for large installations with long length piping supplying several
fluid outlets simultaneously.
This pump can be mounted on the wall, with wall mounting bracket
(Part. No. 360132).
534907
A
The pump starts to pump when an outlet valve is opened, for example
an oil control gun.
Fig. 1
360132
B