Publicidad
Idiomas disponibles
Idiomas disponibles
Place the thick washer (A) on the 60º joint elbow. Then install the elbow on the microscope arm.
Continue placing the fine washer (B) on the arm, as the previous picture. Above it place the
clamping screw (C) and adjust it the maximum. Once it is completely adjusted, dis-adjust it half
turn.
Place the tensor screw (D) and adjusted to the maximum using a corresponding Allen key, as the
following picture.
Then place the embellishing screw (E) on top and adjust it completely. Finally adjust the security
(F) to the maximum.
It is important to adjust the optical head to the arm exactly according to the instructios
on this section, in order to stabelly install the device and prevent damage.
4.5 BINOCULAR-SPLITTER INSTALLATION
Either a binocular and a splitter, or just a binocular can be mounted on the upper side of the
Optical head.
INMANUUML019 USER MANUAL - M. USO OM-200 V.2023.01 ENG-ESP US
USER MANUAL / MANUAL DE USUARIO – MICROSTAR
Tensor screw (D)
Embellishing screw (E)
Security
screw (F)
Page 13 of 64
Publicidad
