Descargar Imprimir esta página

Helite Airbag OFF-ROAD Manual De Instrucciones página 33

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

WHEN DO I NEED TO SWITCH THE AIRBAG OFF?
When you take a means of transport other than the motorcycle with the airbag
(car, metro, streetcar, train, bus, plane, boat, etc.) to avoid causing any unexpected
triggering.
When you are not using the airbag to avoid draining the battery.
d) Change your detection mode : rally/enduro ou adventure.
On the OFF-ROAD airbag the rally/enduro mode
each use, make sure you choose your detection mode according to your application
(see page 29).
HOW TO CHANGE THE DETECTION MODE ?
1
KENNY
Turn on your airbag (see page 32), press the button
1
green LED (rally/enduro mode
2
Hold the button
every 5 seconds. Release the button and proceed to the next step within 30 seconds.
3
Hold the button
cyan LED will alternate, then a series of beeps will sound.
4
At the end of the procedure :
- The LED flashes cyan
- The LED flashes green
GOOD TO KNOW
If the LED turns red and a series of short beeps is heard, the mode change has
failed. You took more than 30 seconds between step 2 and 3, in this case repeat
the procedure.
Mode rally/enduro actived
The LED flashes green
Mode adventure actived
The LED flashes cyan
3
2
AIRBAG TECHNOLOGY
) or a cyan LED (adventure mode
for 3 seconds, the LED will turn blue and a beep will sound
again for 3 seconds. During several seconds a green and a
, adventure mode is activated .
, rally/enduro mode is activated .
is activated by default. Before
For dynamic piloting
You can ride on the trail with
Trail / Maxi trail.
3
sec
AIRBAG TECHNOLOGY
3
4
sec
AIRBAG TECHNOLOGY
3 times quickly. A
) will flash.
33
AIRBAG TECHNOLOGY

Publicidad

loading

Este manual también es adecuado para:

Off-road v2