Publicidad
Select the [Firmware Update] tab.
1
Check the current firmware version.
2
•
The current firmware version of the detector is indicated, and the version appears when a PC is
connected to the detector.
Select the firmware file to update.
3
•
Click [Open] to launch a file explorer. Select the file to update to perform a check to validate the selected
file.
•
If it is a correct firmware file, its name will be shown in the [Firmware File].
•
If an incorrect file is selected, the following pop-up appears.
<A pop-up when the file loading fails>
Update the file.
4
•
Select the file and click the [Update] button to start updating the firmware.
•
The progress will be indicated in the [Firmware Update].
<A pop-up during file updates>
44
•
Check the result.
- The following pop-up appears when the update is completed.
<A pop-up when the file update is completed successfully>
<A pop-up when the file update fails>
[Factory Reset]
5
•
Clicking the button will reset all the DXD settings.
CAUTION
•
Do not remove the power cable until the update is completed. If the detector is turned off while the
update is in progress, it may not work properly.
Publicidad
