Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
ACTIVATION AND REPLACEMENT OF REMOTE CONTROL BATTERY
The remote control has a cell battery already installed. To activate the battery, remove the transparent tab at the
bottom of the remote control. The remote control is now ready to use.
To replace battery:
1. Remove the battery compartment cover as per the illustration shown on the right;
2. Observe the correct polarity and install a 3V
3. Close the cover.
CAUTION
-
Dispose of used batteries according to the recycling regulations in your area.
-
Danger of explosion if battery is incorrectly replaced.
-
Replace only with the same type or equivalent.
-
If the remote control is not used for long periods, the battery can leak and damage the remote control, replace
it with a new one if it should occur.
- DO NOT short-circuit the batteries or throw them in water, general trash or fire.
TRANSPORTATION
Press the button on the handle of the trolley, lift the handle up to the block (you will hear a metallic click). For tran-
sport, by acting on the handle of the trolley, slightly bend the appliance and take advantage of the two rear wheels.
To unlock and close the trolley, press the button on the handle again and lower the handle completely.
For transport, it is also possible to use the two handles placed laterally to the appliance.
POWER/BATTERY CHARGE
This unit works with internal rechargeable Lithium battery 7,4V
When the battery is running low or the device does not turn On, set the main POWER switch (17) to the "OFF"
position, connect the supplied power adapter to the device socket (13) and the plug into a socket and recharge
the internal battery, the LED indicator (15) will turn Red.
- LED indicator light (15) RED fixed: the device is correctly connected to the power cable and the battery is being
charged.
-
LED indicator light (15) OFF: charging operation completed, the battery is charged.
Note: Do not connect the appliance to an outlet with a voltage other than that indicated.
BASIC FUNCTIONS
POWER ON/ OFF
Press the main POWER switch (17) to switch "ON" and use the device with its internal battery.
Press the main POWER switch (17) again to switch "OFF" the device completely or to recharge the battery.
STAND-BY
It is possible to bring the appliance into Stand-by mode using the button
Caution:
-
In Stand-by mode there is no LED that indicates the activation of this function.
-
Leaving the device in Stand-by, the battery tends to discharge faster than using the main POWER switch (17).
MODE
FUNCTION
To change the mode function, press more times the MODE
remote control to select: BLUETOOTH (on display "BLUE"), USB/Micro SD (only if the socket USB (6)/Micro SD socket
(5) is connected to a memory, a small writing "USB" or "TF" appears on the display), AUX-IN (on display "AUX").
ADJUSTING THE VOLUME
1. Turn the VOLUME knob (7) to increase or decrease the general playback volume or use the Vol+ (30) and Vol- (31)
buttons on the remote control;
lithium battery (CR2025);
3600mAh or 9V
(3)
key on the unit or press MODE button (23) on the
12
XF 1250 KB
1,5A adapter supply.
(
24)
on the remote;
Publicidad
